Safety First: Prepare Your Workspace

• Make sure your vehicle is on a flat, stable surface.
• Engage the parking brake and turn off the ignition.
• Put on safety gear: gloves and safety glasses.

Assemble Your Tools and Materials

• A jack and jack stands.
• A lug wrench.
• A C-clamp or brake caliper piston tool.
• A socket set.
• New brake pads for a 2019 Toyota Camry.
• Brake grease or anti-squeal lubricant.
• A tire iron.
• A flathead screwdriver.

Loosen the Lug Nuts

• Use the lug wrench to slightly loosen the lug nuts on the wheel you are working on. Do not fully remove them at this point.

Jack Up the Car

• Position the jack under the vehicle's jack point, typically located under the chassis near the wheel well.
• Lift the car with the jack until the wheel is off the ground.
• Place jack stands under the chassis for added safety.

Remove the Wheel

• Proceed to remove the loosened lug nuts.
• Take off the wheel and place it aside.

Access the Brake Caliper

• Locate the brake caliper mounted over the brake rotor.
• Use a socket or flathead screwdriver to remove the caliper bolts, typically located at the back of the caliper.
• Carefully slide the caliper off the brake rotor. Suspend it with a bungee cord or wire hanger to avoid straining the brake line.

Remove the Old Brake Pads

• The old brake pads are seated in the caliper bracket.
• Slide them out by hand. If they resist, use a flathead screwdriver to gently pry them free.

Install the New Brake Pads

• Apply brake grease or anti-squeal lubricant to the back of the new brake pads.
• Insert the new brake pads into the caliper bracket, ensuring they are securely seated.

Retract the Caliper Piston

• Use a C-clamp or a brake caliper piston tool to push the caliper piston back into its bore. This step is necessary to accommodate the thickness of the new brake pads.

Reattach the Brake Caliper

• Align the caliper over the new brake pads on the rotor.
• Reinstall the caliper bolts to secure it in place.

Reinstall the Wheel

• Place the wheel back onto the hub.
• Hand-tighten the lug nuts.

Lower the Vehicle and Tighten Lug Nuts

• Use the jack to carefully lower the vehicle back to the ground.
• Once on the ground, use the lug wrench to fully tighten the lug nuts in a crisscross pattern to ensure even pressure.

Test the Brakes

• Pump the brake pedal a few times to ensure the brake pads are properly seated.
• Perform a low-speed test drive to check braking performance before returning to normal driving conditions.

By following these steps, you can effectively replace the brake pads on your 2019 Toyota Camry. Always consult your vehicle’s owner manual for any specific instructions or warnings related to your model.